Arduino Uno Schematic

Arduino Uno is an open source  microcontroller board based on  ATmega328P .It can be powered through a standard USB port OR a common 5 Volt Power adapter and can be programmed with easy to use Arduino IDE on Windows , Mac OS OR Linux.…

Introduction to Arduino Uno

 Aduino Uno Board Arduino Uno board is a very popular microcontroller( ATmega328P ) based board with 14 digital input and output pins, 6 analog inputs, onboard 16 MHz quartz crystal oscillator , a USB interface,…

nRF24L01 Single chip 2.4 GHz Transceiver

nRF24L01 radio transceiver for the world wide 2.4 - 2.5 GHz ISM band. It is a single chip module consists of a a power amplifier, frequency synthesizer, a crystal oscillator, a demodulator, modulator and an Enhanced ShockBurst™ protocol…

HC-05 Bluetooth Module

HC-05 Bluetooth is an easy to interface SPP (Serial Port Protocol) Bluetooth module. It communicate via serial communication which makes an easy way to interface with controller or a PC. This module provides user switching mode between…

MQ-6 Propane Gas Sensor Module

MQ-6 is a propane gas Sensor Module with a high sensitivity and fast response time. The sensor’s output is an analog resistance. The driving circuit is very simple; only requires to power the heater coil with 5V, adding a load resistor, and…

Arduino Nano Schematic

The Arduino Nano is a  board which is  based on ATmega328. It can be powered through Mini-B USB connection, 6-20V unregulated external power supply, and 5V regulated external power supply. Consult Arduino Nano schematic for more info.…

Arduino Nano Specifications

The Arduino Nano is a small form factor, breadboard friendly unit based on ATmega328. It can be powered through Mini-B USB connection, 6-20V unregulated external power supply (pin 30), and 5V regulated external power supply (pin 27).…

DHT22 Digital Temperature and Humidity Sensor

DHT22 is a Digital Temperature and Humidity Sensor Module. It’s a low cost temperature and humidity sensor with a capacitive humidity sensor and a thermistor to measure the surrounding air, and provide a digital signal on the data pin. It…

DHT11 Temperature and Humidity Sensor

DHT-11 is a digital temperature and humidity sensor with full scale calibration, digital output, humidity measurement range: 20% to 9 0%RH (0-50 ° C temperature compensation); temperature measurement range: 0 to +50 ° C; Its humidity…

Digital Infrared Temperature Sensor

MELEXIS MLX90614ESF Digital Infrared Temperature Sensor This Digital Infrared Temperature Sensor is a  MELEXIS MLX90614ESF-BAA-000-TU-ND non-contact infrared thermometer for Arduino and  other microcontrollers which can communicate with…

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More